Make sure the USB light on the front of the Gateway glows solid green. Disabling NAT allows the computers connected to the Gateway to be accessed by outside parties. Get the yellow Ethernet cable from the kit and plug one end into a Yellow port on the back of the Gateway, then click Next. Enter text from picture: In this screen, the user can configure the IP configuration Dynamic or Static. Published on December 18,.

Uploader: Arazahn
Date Added: 2 December 2011
File Size: 40.82 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 13313
Price: Free* [*Free Regsitration Required]

Page 22 Chapter 2 Setting Up the Gateway 2.

Select Address from the menu on the left side. This amount is subject to change until you make payment. All telephones and other devices answering machines, fax machines, etc. Plug the larger end of the Power cord into a power outlet, then click Next.

Actiontec GT701-WG

If you want to take your computing to the next level, the Actiontec 54 Mbps Wireless Ueb is sure to be one of the keys ubs your success. Allows error messages, text packages, and informational messages to be transferred over the Internet. Chapter 2 Setting Up the Gateway If the document is not available, contact the immediately. Read the on-screen instructions regarding the terms and agreements of the rental contract, click in the white circle next to I accept this agreement, then click Next.


The Gateway has been configured to support a single static Power light stops blinking, the Gateway is ready for use. Page of Go. These addresses should be included on the 7.

ActionTec GT701-WG User Manual

Read the instructions, select Initial Setup by clicking on the appropriate check box, then click Next. Wireless Light – The Wireless light illuminates when the Modem is connected wirelessly.

Doing so may result in permanent damage to the Gateway. Comments to this Manuals Your Name. Make sure to write this password down and keep it in a secure location.

Before attempting any of the above, make sure access to the Internet is available. If the Power Light glows steadily green, the Gateway is receiving power and fully operational.


Get the purple Sub cable from the kit and plug one end into the Purple port on the back of the Gateway, then click Next.

I just connected it to power, phone line, and PC. Gt701-wt you have satisfied the above requirements, your next step would be to plug the MicroFilters into each telephone jack to which a telephone is connected. Page of 2 Go.

– ActionTec GTwg Configuration

Plug the other end of the green computer. Published on December 18. Actiontec recommends keeping gt701-qg fac- tory default setting Some Security Alarm Systems or Automatic Water Meters may be “hard wired” into your telephone system which would require that your DSL installation be performed by a Qwest technician at extra charge.


If not, leave the text box intact. Electronic Security Appendix C Computer Security Network Applications Network applications such as software programs that allow remote access to the computer also make the computer vulnerable to access from other bt701-wg on the Internet. Make sure one of the Ethernet Network Lights glow steadily green, then click Next.

Enter the Address, Subnet, Gateway, 1, and 2 information if applicable in the proper text boxes. If not installing a wall-mount phone filter, go step 7. If there is more than one Local Area Connection listed, locate the one that cor- responds to the network card installed in the computer by finding the name of the network card in the Device Name column.

Other types of broadband Internet connections such as fixed point wireless may use either or Static DHCP is present, check with the Internet Service Provider continuing. This setting is for enterprise networks only, and should be accessed by experienced information systems spe- cialists only.

In this screen, the user can configure the IP configuration Dynamic or Static.